Cleaning Your HuniTip

Items Needed:

• Small Metal Tool or Paperclip
• Fully Charged Battery
• 91% Isopropyl Alcohol
• Cotton Swabs
• Paper Towels

Step 1: Unscrew the HuniTip from the Huni Badger. Excess residue can make the HuniTip difficult to remove.

Step 2: Lightly coat paper towel with isopropyl alcohol to wipe the outer wall and threads clean.

Step 3: Screw the HuniTip back in.

Step 4: Turn the Huni Badger on with 5 clicks & let it run for a full cycle (60 seconds). Allow enough time for the HuniTip to cool down.

Step 5: Carefully scrape the inside of the HuniTip to loosen and remove the carbon buildup. Be careful not too far as this could damage the internal connecting points.

Step 6: Soak a cotton swab in isopropyl alcohol and wipe off excess. Insert the cotton swab into the HuniTip and slowly twist to clean the walls. Repeat as needed until HuniTip is clean.

Step 7: Turn the Huni Badger on with 5 clicks again and burn-off the residual isopropyl alcohol. While the Huni Badger HuniTip heats up, you may be able to see the carbon burning off of the ceramic. Keeping your HuniTips maintained will keep your Huni Badger working effectively!